Revisions and Updates information
Check here for notes about the latest updates and any revisions to schematics etc
Date: 30th January 2018
New Photographs Page added. Best place to find general InMoov pictures
See page here
Date: 2nd January 2018
R2D2 build page
Comment on InMoov printing times and plastic used, in comparison to the estimated R2D2 build.
Date: 30th December 2017
New PAGE added. This is for a new project, the 3D printing and assembly of a full size R2D2 astromech droid. See page here
Date: 8th December 2017
Added comment to schematic showing LED fuse indicators on Control System page. The LEDs I use have built in resistors, but if your LEDs are not like these, add in a resistor in series with each of your LEDs [Light Emitting Diodes] of approx 330-470 Ohms, experiment for the brightness required.
Date: 2nd December 2017
I have added a new page, Ez-Builder for Windows - robot control software
This page describes my own programming setups with the software.
Note that my V9 software setup is not available yet as a download. Soon!
Schematic - Resetable Fuse Boards V1 revision to V2 with corrected pins outs and again to V2b
This version added to "InMoov Control System" page here
Many photographs added to control page
Date: 10th November 2017
Additional photographs of fused PCB boards and revised text
This added to "InMoov Control System" page here
Hi Kyle, thanks for the information! I am currently working on the new hand model with micro servos in the palm, it’s going well, I noticed that gael rotated his micro servos 90° and it seems to be a good idea. Do you have a vid or a site to help in the HK15338 mods? I am doing the upper stomach like you did and would like to see the process. Thanks! James
ReplyDelete