To all you 3D Printer owners - print these!!!
Have a look at the Prusa Face Shield COVID-19
You can make these yourselves and help your local doctors surgery.
See link HERE
My first attempt works fine. This is the V2 version
This was printed at 5% infill in PLA, see below.
I have now printed the V3 version with 10% infill and very successful. I printed the quad stack of bands overnight but had real trouble separating them and damaged two in the process, so that was a fail!
I am now printing in PETG but with blue painters tape on the print bed because its damaged the bed so badly in the past by sticking to it and pulling up the surface.
Prints are working OK with it now.
You can make these yourselves and help your local doctors surgery.
See link HERE
My first attempt works fine. This is the V2 version
This was printed at 5% infill in PLA, see below.
I have now printed the V3 version with 10% infill and very successful. I printed the quad stack of bands overnight but had real trouble separating them and damaged two in the process, so that was a fail!
I am now printing in PETG but with blue painters tape on the print bed because its damaged the bed so badly in the past by sticking to it and pulling up the surface.
Prints are working OK with it now.
Comments
Post a Comment